Table of Contents
Advertisement
2. Other
2.3.12
Punch shift motor (M5)
1. Remove the Z folding unit.
See P.13
2. Remove the rear cover.
See P.10
[2]
[1]
a
a
5. To reinstall, reverse the order of removal.
24
[1]
[3]
A07TF2C021DA
[2]
[3]
A07TF2C022DA
A07TF2C514DA
Service Manual
Field Service Ver. 2.0 May 2008
3. Disconnect two connectors [1] and
remove three screws [2], and remove
the punch shift motor assy [3].
4. Disconnect the connector [1] and
remove two screws [2], and remove
the punch shift motor [3].
NOTE
• When installing the punch shift
motor assy, adjust its position so
that there is a clearance of "a", as
specified below, at the front and
rear sides and make sure that the
motor assy is horizontal.
Adjustment value: "a" = 2 mm
Y107910-0
Advertisement
Table of Contents
