Frigidaire cgis3065pf Use & Care Manual page 40

CARE AND CLEANING
Removing and Replacing the Oven Door
To remove oven door:
1. Open oven door completely, horizontal with floor
(Figure 43).
2. Pull the door hinge locks on both left and right door
hinges down from the oven frame completely towards
the oven door (Figure
blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle
4. Close the door to the cambered stop position (the oven
door will stop into this position just before fully closing).
5. Lift the oven door hinge arms over the roller pins
located on each side of the oven frame
To replace oven door:
CAUTION
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
1. Firmly grasp both sides of oven door along the door
sides. Do not use the oven door handle
2. Holding the oven door at the same angle as the removal
position, seat the hook of the hinge arm over the roller
pins located on each side of the oven door frame
(Figure 45 and Figure
must be fully seated onto the roller pins.
3. Fully open the oven door, horizontal with floor
(Figure 43).
4. Push the door hinge locks up towards and into the oven
frame on both left and right oven door hinges to the
locked position (Figure
5. Close the oven door.
IMPORTANT
Special door care instructions - Most oven doors contain
glass that can break. Do not close the oven door until all
oven racks are fully in place. Do not hit the glass with
pots, pans, or any other object. Scratching, hitting, jarring,
or stressing the glass may weaken its structure causing
an increased risk of breakage at a later time.
40
44). A tool such as a small flat-
(Figure
(Figure
(Figure
46). The hook of the hinge arms
44).
Figure 43: Door hinge location
45).
45).
Figure 44: Door hinge locks
45).
oven
door
Figure 45: Holding door for removal
roller
pin
hinge
arm
Figure 46: Replacement and location of hinge arm and
roller pin
Oven door
hinge
locations
about
10°
hinge