Setting Surface Controls - Frigidaire cgis3065pf Use & Care Manual

SETTING SURFACE CONTROLS

SETTING SURFACE CONTROLS

Cooktop Display Windows
The range backguard provides a digital window for each
cooking zone on the cooktop. Power levels and messages
are monitored and controlled using the window displays in
combination with the corresponding control knobs.
Available Power Level Settings
The cooktop control (Figure
ranging from Lo to Hi to Pb
located above each control dial. The settings range is
between 1.5 and 9.5 (Figure
ments.
Use the suggested cooking zone power level settings table"
on page 13 to determine the correct power level setting for
the type of food you are preparing.
Power Boost (Pb) Power Level
When setting an induction cooking zone for Hi, the display
will initially show Pb power level for up to 10 minutes
(Figure 9). After 10 minutes the cooking zone will automati-
cally return to the Hi setting. The Pb setting is only available
immediately after activating a cooking zone by turning the
knob to Hi.
Hot Element (HE) Surface Window Message
When using a cooking zone, the cooktop may become very
hot. After turning any cooking zone off, the cooktop may
remain hot for some time. The corresponding HE
(Figure 11) message displays until the cooktop has cooled.
ESEC Error Indicator Message (Er)
An error message will display flashing Er
power up or after a power failure for any surface control
knob not in the OFF position. If a power failure should
occur, set all surface control knobs to OFF
will reset the surface controls.
Also, reset the clock (page
have been set to off and the clock has been set with the
correct time of day, the surface controls should return to
normal operation. If the surface controls do not function and
the Er message remains in any display after following these
procedures, contact an authorized service provider for
assistance.
12
8) displays power levels
(Figure 9) in a display window
10), adjustable in 0.5 incre-
(Figure 12) at
(Figure 8). This
20). Once the surface controls
Figure 8: Typical induction cooktop controls
Figure 9: Power setting indications
Figure 10: Power level ranges
Figure 11: Hot element display
Figure 12: ESEC error indication
Lockout Window Message
The (- -) message appears whenever Lockout, self clean, or
Sabbath is active (Figure
Feature" on page 22 for more details.
Figure 13: ESEC error Indication
IMPORTANT
Induction cooking zones will not operate when the oven is
set for Sabbath mode. For more details on the Sabbath
feature, see "Setting the Sabbath Feature"
13). See "Setting Oven Lockout
on page 32.