Rigging The Mast - RS LDC 2000 Rigging Manual

To complete this section you will require:
 The mast
 A flat-bladed screw driver, pozidrive screwdriver and a 8mm spanner
Fitting the Spreaders
It is worth taking time to ensure that this section is completed correctly.
Improperly fitted spreaders will result in strange sailing characteristics, and
may even result in failure of the mast.
1. Carefully unpack the spreaders from the top of the mast, being sure not
to damage or lose any of the securing split rings.
2. Unwind the shrouds and forestay from around the mast, and unwrap
from the packaging.
Trapeeze
4. To fit the spreaders
inboard end, refer to the
table below and the Selden
Vernier Adjustment
Instructions page.

3.3 Rigging the Mast

Shrouds
7
3. Connect
the
Shrouds to
the lower
key hole in
the mast