Table of Contents
Advertisement
3.3 - Rigging the Mast
If you have the
the Jib, and Section 3.11 Rigging the
the boat.
To complete this section, you will need:
• The
mast top section
• The
mast lower section
• The
main halyard
a)
• Place the
mast top section
each other.
b)
• Slide the inner sleeve of the
• Push the two
mast track
on the two sections aligns.
c)
• Uncoil the
• Thread one end of the
the bullseye at the top of the mast.
• Run both ends of the
of the
mast
from disappearing back up the mast!).
Please note, top and bottom
so if you have more than one boat you should consider marking the sections to identify
which go together.
Jib
and/or
Gennaker
and
mast top section
mast
sections together. The angle of the join should ensure that the
main halyard
main halyard
main halyard
and tie in place (this prevents them
mast
Pack, please refer to Section 3.4 Rigging
Gennaker
before stepping the
mast lower section
into the end of the
through
to the bottom
sections are matched, they are not interchangeable
on the ground, in line with
mast lower
mast
in
section.
Advertisement
Table of Contents
