Configuration Mode And Settings - Garmin GTX 3X5 Installation Manual

6.3

Configuration Mode and Settings

NOTE
Screenshots are for illustrative purposes only. They do not imply the shown setting(s)
should be used in any installation.
System and interface settings are shown in configuration mode and are unique to the GTX 3X5
installation. The configuration settings are stored in internal memory. If connected, the configuration
module stores configuration settings. The optional GAE module operates as a configuration module. In this
section, configuration instructions are for panel mount units. Refer to section 6.11 to configure remote
units.
On a panel mount unit push and hold the ENT key and apply power to enter configuration mode.
• Push and hold the OFF key until the unit powers off to exit configuration mode.
• Push the FUNC key to cycle through the group pages.
• Push the 8 or 9 key to scroll up or down on the page without an active field selected.
• Push the CRSR key to access items on the page.
• Push the 8 or 9 key to cycle through the selections of an item on the page.
• Push the ENT key to move within the page with a field highlighted or to accept setting.
• Push the CLR key to move to previous selection on the page.
• Push the FUNC key to exit the page.
190-01499-02
Rev. 4
GTX 3X5 Transponder TSO Installation Manual
Page 6-2