Related Manuals for Sea Eagle FastTrack Angler 385fta
Summary of Contents for Sea Eagle FastTrack Angler 385fta
- Page 1 FastTrack Angler ™ 385fta Instruction & Owner’s Manual For video instructions visit SeaEagle.com/Instructions Sea Eagle Boats Inc. 19 N. Columbia Street, Suite 1 Port Jefferson, NY 11777 1-800-748-8066 April 2017...
- Page 2 All Sea Eagle products come standard with a 3 year warranty against manufacturing defects The warranty begins the date that your product is delivered. Sea Eagle must inspect equipment in order to determine if there is a defect. In the event that an item must be shipped back to us, Sea Eagle will only reimburse the standard return shipping charge through FedEx, UPS, or U.S.P.S.
-
Page 3: Boating Safety Tips
USCGBoating.org or enroll in a water safety course given by a local provider. As a safety reminder, each Sea Eagle has a safety summary we call Boating Safety Basics printed on it. Please follow these suggestions and use good boating safety practices. In addition to the basics, we suggest you have a reasonable swimming ability and know that it is safer to go boating with a buddy. - Page 4 BEFORE & DURING USE: Avoid damage. Do not drag your Sea Eagle over abrasive surfaces like asphalt parking lots, gravel or concrete boat ramps, whether the boat is in its bag or inflated. Carry or wheel your Sea Eagle from the car to the setup point, and then to the water when assembled.
- Page 5 Allow the Sea Eagle FastTrack to make your life better and more fulfilling. Carve out time to use the kayak as often as possible. Get the most out of the purchase by using it regularly and frequently. Maintain the kayak according to Cleaning and Protecting...
- Page 6 FastTrack| SETUP: VALVES & PUMPS The 385FT has one valve The correct adapter for for each side chamber, the valves is pre-installed one valve for the in the hose. If adapter is removable floor and a too tight, stretch red keel valve under the spray gasket to soften it.
- Page 7 FastTrack| SETUP: VALVES & PUMPS Locate the gray adapter Screw the other end of with red gasket. Press the hose onto the red and twist this adapter inflation port on the firmly onto the gray tube end of the pump. at the end of the black hose.
-
Page 8: Assembly & Inflation
30 psi) can easily skeg will not slide into over-inflate and cause the base, do not force it. harm to your Sea Eagle Refer to troubleshooting that uses a much lower section. Do not use skeg pressure. For this reason, in whitewater. - Page 9 FastTrack | ASSEMBLY & INFLATION Floor Drains Screw the floor drain caps down tightly. Drains Inflate sides should be closed during to 3.2 psi. PSI is marked use except in whitewater in red. situations. Boat will partially fill with water Note: Pressure gauge will with drains open.
- Page 10 FastTrack | ASSEMBLY & INFLATION One-Way Air Valve (Found only on DKSG) Lay board over rear Tether the valve onto the D-rings. Bolt brackets to valve bases by stretching board using the shorter the retainer rings to fit bolts (M8x40) and knobs. over the groove in the Use long bolts (M8x50) bases.
- Page 11 FastTrack | ASSEMBLY To attach TBS with motor mount. First clip seat to D-rings just forward of motor mount position. Follow motormount Use the wide, flat attachment instructions adapter to inflate the from page 9. seat. Footrest Run strap through clip loops.
- Page 12 FastTrack | ASSEMBLY Fully assembled and ready to go. Next, slide the drip guards up the shaft to about an inch above the button hole. Insert the blades into the shaft and adjust until the button locks the blade in place. Deluxe Solo The additional holes in the shaft are for...
-
Page 13: Cleaning & Protecting
Storage Tips: “The best way to store a Sea Eagle is folded up in it’s bag”. - Cecil Hoge, Jr., Sea Eagle President •... -
Page 14: Troubleshooting
Repair kits also include a valve wrench. If your Sea Eagle has lost pressure, it does not necessarily mean it is leaking. If it is inflated during the heat of the day and the temperature drops during the night it will be softer in the morning. - Page 15 FastTrack| REPAIRS Patching Tips: • The the chamber must be deflated or the air will force a path through the glue. • Keep the patch size to a minimum, the bigger the patch, the harder it is to seal. The most common repair failures Patching occur because the patch is too big.
-
Page 16: Optional Accessories
FastTrack| OPTIONAL ACCESSORIES EZ Cart Small (OPTIONAL) Transport your SUP from your car to the water and Sea Eagle off ers a large back with ease. Quickly array of accessories for assembles & disassembles. your FastTrack. 303 Protectant (OPTIONAL) Extends the life of your Sea Personal Eagle.