Table of Contents
Advertisement
Installation Instruction
Fixing Cooker Hood
Connection of
Exhausted Pipe
Ø175mm
Hang the cooker hood on to the fixing brackets on the
wall. Make sure the cooker hood does not shake or
hook off. Keep the cooker hood horizontal.
Install the accessory fixing screws in the notch as
shown in the figure to prevent the cooker hood falling
off from the mounting rails.
Each cooker hood is equipped with a exhausted
plastic pipe in a diameter of 175 mm. The exhausted
pipe is 1.65 m long when completely stretched.
Maximum 1.65 m
Please connect one end of the exhausted pipe to the
outlet duct on the cooker hood and connect the other
end of the exhausted pipe to the common chimney
duct or the drilling hole in the external wall (the
diameter of the drilling hole is 180 mm).
Common chimney duct
For optimum extractor hood efficiency:
1. Diameter of pipe to be as large as possible and no
tight bends in pipe.
2. The exhausted pipe cannot be bent into a "凹" shape
(as few bends as possible).
3. Do not connect the exhausted pipe to another pipe
with a diameter smaller than 175 mm.
4. Do not use a pipe with a diameter smaller than 175
mm with a intermediate connecting pipe.
Directly discharge outside the wall
Minimum 30 mm
Ø175mm
12
Ø175mm
Advertisement
Table of Contents
