Trouble Shooting - Bosch DKS968D Operating And Installation Manual

Table of Contents

Advertisement

Cleaning Maintenance and Repair
Oil Collector

Trouble Shooting

Problems
Appliance cannot work.
The motor does not work and
the lamp cannot be turned on.
The motor works but the
lamp cannot be turned on.
The suction force is not
strong enough.
"E1" shown in screen when
self cleaning is operating.
"E2" shown in screen, fan
can work, discontinuous
beeps and all control buttons
locked when self cleaning is
not operating.
When two third of the oil collector is filled up, the oil
collector should be cleaned to avoid any oil spills.
Detach the oil collector according to the figure.
Caution!!!
The cooker hood may cause a fire, if the oil collector
is not cleaned according to the methods mentioned in
the operation instruction.
Caution!!!
Maintenance of the cooker hood should only be done
by qualified technicians.
Refer to the following table for any possible
malfunctions and remedy. If the malfunction is still
present, pull out the plug of the cooker hood and
contact our customer service centre.
Possible cause
Electromagnetism
disturbance
The plug is not or improperly
inserted or no power supply.
The lamp is damaged.
Not adjusted to the
maximum fan speed.
Air convection is strong.
Self cleaning function is
defected.
Self cleaning controling
components is broken.
If one of the following malfunction occurs, please pull
out the electric plug of the cooker hood at once and
contact our customer service center.
Irregular operating sounds are heard after the cooker
hood is turned on.
Vibration occurs during the operation of the cooker
hood.
Smell, smoke or heat released from the cooker hood.
Notes/Remedy
Pull out the plug, Re-insert it
after 1 min
Make sure the plug is inserted
properly. Ask an electrician to repair.
Replace the lamp.
Adjust the fan speed to the
maximum rank.
Close the window at one side.
Pull out the plug, Re-insert it
after 1 min.
Pull out the plug, Re-insert it
after 1 min. If this problem can
not be removed, please pull out
the plug and contact Siemens
customer service centre.
15

Advertisement

Table of Contents
loading

Table of Contents