Installation; Electrical Data; Mounting The Hood Body - Bosch DWK096750 Operating And Installation Instructions

Electrical connection

Electrical data:

Are to be found on the name plate inside the appli-
ance after removal of the fi lterframe.
Before undertaking any repairs, always
disconnect the extractor hood from the electricity
supply.
Length of the connecting cable: 1.30 m.
This extractor hood corresponds to EC regulations
concerning RF interference suppression.
Risk of electric shock!
The appliance features an EU safety plug. To ensure
protective earthing in a Danish socket, the appliance
must be connected to a suitable plug adapter. This
adapter (permitted up to max. 13 amps) is available
from customer service (spare part no. 616581).

Installation

This extractor hood is intended to be mounted
onto the kitchen wall.
1. Unhook the ducting panels and the metal fi lters
(see maintenance chapter)
C
mind 368 Elektro / Gas
Note: Take into account any special accessories
that are going to be fi tted.
A
B
Installation
2. Draw a line on the wall from the ceiling to the
lower edge of the hood at the centre of the lo-
cation where the hood is going to be mounted.
3. Use the template or following the picture to
mark the points (A-B-C) on the wall where the
screws will be mounted.
Ensure that the minimum distance between the
hob and the extractor hood is maintained – 368 mm
for the electric or gas hob.
4. Drill ø 8 mm holes A and B for the extractor
hood. Drill ø 8 mm holes C for the chimney
brackets.
5. Insert plugs 11 into the holes so that they are
fl ush with the wall.
6. Fix the brackets 7.2.1 using the 12a screws
supplied.
In case of hood installation in recycling version
with the chimney, the upper bracket 7.2.1 must
be fi xed together with the Air Outlet Connection
Support 7.3
.
7. Insert two screws 12a supplied in the hood
body fi xing holes, leaving a gap of 5-6 mm be-
tween the wall and the head of the screw.

Mounting the hood body

8. Before attaching the hood body, tighten the two
screws Vr located on the hood body mounting
points.
12a
9. Hook the hood body onto the screws 12a.
10. Fully tighten support screws 12a.
11. Adjust screws Vr to level the hood body.
12. Tighten the safety screw 11 in holes B.
en
Vr
23