Daikin BRC1E62 Installation Manual page 16

Mode
FIRST
No.
CODE
Note) 1 NO.
ON/OFF input from outside (Setting
for when forced ON/OFF is to be
1
operated from outside).
12 (22)
Thermostat differential changeover
(Setting for when using remote
2
sensor).
High ceilling setting (Setting for
when installed in ceilling higher than
2.7m).
* H eight depends on the connection
0
model.
Refer to the installation manual
attached to the indoor unit to be
connected for details.
Selection of airflow direction (Setting
for when a sealing pad of air
1
13 (23)
discharge outlet has been installed).
Selection of airflow function (Setting
for when using a decoration panel
3
for outlet).
Airflow direction range setting.
4
Setting the external static pressure
(Setting according to the connected
duct resistance)
6
For FHYK
Drain pump operation with
15 (25)
3
humidifying.
Thermostat sensor in remote
controller (For Auto mode and
1c 1
Setback function only)
1e Setback function
2
Notes) 1. Though setting is performed totally in the group, set Mode No. in the parenthesis when
individual setting per indoor unit or checking after the setting should be performed.
2. SECOND CODE NO. at factory shipment is set to "01".
However for the following cases it is not "01".
● Airflow direction range setting (except Round flow cassette) ... "02"
● Thermostat sensor in remote controller (SPLIT system only) ... "02"
● Thermostat sensor in remote controller for auto mode and Setback function
only ... "02"
● Setback function ... "04"
3. Any function which the indoor unit does not have is not displayed.
15
Description of setting
SECOND CODE NO. Note) 2
01 02
ON/OFF
Forced OFF
operation
0.5°C
1°C
2.7m<,
≤ 2.7m
≤ 3.0m
*
*
4-way air 3-way air
discharge discharge
Equipped Not equipped
Upper Normal
High static
Normal
pressure
Normal High ceiling
Equipped Not equipped
Not use Use
Not use Heating only
03 04
— —
— —
3.0m<,
≤ 3.5m
—
*
2-way air
—
discharge
— —
Lower
—
Low static
—
pressure
— —
— —
— —
Cooling
Cooling
and
only
Heating