Cable Connections - HP ProLiant SL335s G7 Maintenance And Service Manual

•
Never crease a SATA data cable.
•
Do not rely on components like the drive cage, power supply, or system cover to push cables down
into the chassis.
Removing power supply cables from the system board connectors (J26) follow below steps:
1. Squeeze on the top of the retaining latch attached to the cable end of the connector.
2. Grasp the cable end of the connector and pull it straight up.
CAUTION: Always pull the connector - NEVER pull on the cable. Pulling on the cable could damage
the cable and result in a failed power supply.
Figure 5 Unplugging power cables

Cable connections

The following table provides information about cable connector.
Table 1
Cable connection for SATA LFF HDD (3.5 inch hard disk)
Cable
SATA cable 1, 2, 3, 4
(two branches each cable)
Table 2
Cable connection for SAS LFF HDD (3.5 inch hard disk)
Cable
Mini-SAS cable
(four branches)
Power cable
Data cable
Power cable
Data cable
From
HDD 1,2,3,4
HDD 1,2,3,4
From
HDD 1,2,3,4
HDD 1,2,3,4
Removal and replacement procedures 32
To
P1, P2, P3, P4 on
personality board
J33, J35, J36, J37 on MB
To
P1, P2, P3, P4 on the
personality board
J7 on P410 card