Advertisement
1. First, loosen the two locking knobs (A), SEE FIG.16
2
s
Adjusing of 90 degree:
3. Loosen the M6 Hex Nut (A) by open wrench. SEE FIG.17-1.
4. Put a gauge block (C) on the table with one end against the
fence, then adjust the set screw (D) by hex wrench till the fence
is exactly 90 degrees to the table, and then lock the M6 Hex
Nut (E) by open wrench. SEE FIG.17-2.
5. Finally, tighten the two locking knobs in place (A) . Ensure
the fence and table are still in contact with the gauge block.
SEE FIG. 18-1, 18-2.
.
Fig.17-1
Fig.18-1
Fig.17-2
Fig.18-2
Adjusing of 135 degree:
6. Loosen the M6 Hex Nut (A) by open wrench. SEE FIG.19-1.
7. Put a gauge block (C) on the table with one end against the
fence, then adjust the set screw (D) by hex wrench till the fence
is exactly 135 degrees to the table, and then lock the M6 Hex
Nut (E) by open wrench. SEE FIG.19-2.
8. Tighten the two locking knobs (A) in place, ensure the fence
and table are still in contact with the gauge block.
SEE FIG. 20-1, 20-2.
.
Fig.19-1
Fig.20-1
NOTE: These positive stops enable you to quickly position
the fence to the 90 and 135 degree seetings.
c
20
Fig.19-2
Fig.20-2
Advertisement
