Selecting The User Clip Name Recording Method - Panasonic AG-HMC80P Operating Instructions Manual

Clip metadata (continued)
4
Press the up or down button of the cursor
button to switch pages, select META CARD
READ, and press the ENTER button.
META CARD READ:
Read metadata set to the SD Memory Card
with the camera.
Up to 8 metadata files stored on the SD
Memory Card (MTDT00 to MTDT07)
are displayed in a list. Files with no
corresponding data are displayed in gray.
When you select the file you want to
read by pressing the ENTER button, a
confirmation message appears. Select
YES and press the ENTER button to read
the metadata.
META DATA REC:
Select this to set whether to record the
metadata to be loaded into the unit
simultaneously on the SD Memory Card.
Select ON and press the ENTER button to
set metadata recording.
The icon appears on the LCD monitor.
META
The factory setting for this mode is OFF.
USER CLIP NAME:
The USER CLIP NAME recording method
is selectable. For details, see "Selecting the
USER CLIP NAME recording method".
META DATA PROP:
Select this to display metadata that has been
loaded to the unit.
CLIP COUNTER RST:
Reset the COUNT value to 1.
Select YES and press the ENTER button to
reset.
24
META INITIAL SET:
Select this to initialize the metadata which
has been recorded in the unit.
Select YES and press the ENTER button to
initialize.
5
Press the MENU button to release the menu
mode.
Selecting the USER CLIP NAME
recording method
You can set the recording method for USER CLIP
NAME by selecting the USER CLIP NAME item
in the setting menu RECORD SETUP screen and
then pressing the ENTER button. The TYPE1 and
TYPE2 options are available for selection.
USER CLIP NAME to be recorded
TYPE1
If clip metadata has Uploaded
been read in data
If no clip metadata
has been read in Sequential 5-
or if the setting digit number,
for recording clip in order of
metadata has been recording
turned off
*
The COUNT value is indicated as a four-digit
number. The COUNT value is incremented each
time a new clip is captured if clip metadata has
been read in and TYPE2 has been selected as
the recording method.
The COUNT value can be reset using the
following procedure.
Select YES for the CLIP COUNTER RST item
in the setting menu RECORD SETUP screen,
and then press the ENTER button to reset the
COUNT value to 1.
TYPE2
Uploaded data
+ COUNT
*
value
Sequential 5-
digit number,
in order of
recording