Clip Operations; During Clip Playback - Panasonic AG-HMC80P Operating Instructions Manual

Clip operations

Video data recorded in CAMERA mode is referred to as a clip. When you enter PB mode, thumbnail
images of clips appear on the viewfinder. (The thumbnails may take longer to display with higher quantities
of clips.)
You can perform the following operations when using the thumbnail screen in DV mode.
• Play, restore and delete clips
• Format SD Memory Cards
• Add or delete shot marks
•
• To use the standard setting menu (PLAY SETUP etc.), press and hold down the MENU button
(approx. 3 seconds).

During clip playback

Thumbnail display
1 Thumbnail mode display
Displays the selected thumbnail mode.
2 Thumbnail
A thumbnail of the clip.
3 Remaining battery display
Displays the remaining battery capacity.
4 Thumbnail menu display
Displays the thumbnail menu.
5 Clip number
Displays in the order recorded. Clip numbers
will be displayed in red for clips with invalid
recording formats or other clips that cannot be
played back.
6 START TC
Displays the time code value at start of
recording.
Clip information display
7 Incomplete clip indicator
When the recorded memory of a single clip
exceeds 4 GB (approx. 16 minutes of recording
time), the clip will be divided automatically and
saved as separate related clips. If the battery
runs out while shooting, for example, and the
final clip could not be saved properly as a
related clip, this indicator will be displayed for
that clip.
You can restore the full sequence of related
clips by restoring the final clip with this unit.
(Page 82)
8 Faulty clip indicator
Displayed for clips that were unable to record
properly due to causes such as the power
being turned off while recording.
It may be possible to repair clips displayed with
a yellow faulty clip indicator. (Page 82)
(Continued on the next page)
79