Table of Contents
Advertisement
Available languages
Available languages
Restoring Factory Defaults
Restoring Using the CLI
To restore the appliance through the CLI:
1. Log in to the appliance.
2. Run this command from clish:
set fcd revert <image_name>
For example: set fcd revert Gaia_R77.30
A reverting to factory defaults message is shown.
50
|
Check Point 15000 and 23000 Appliances Getting Started Guide
Advertisement
Chapters
Table of Contents
Need help?
Do you have a question about the 15000 and is the answer not in the manual?