Table of Contents
Advertisement
9
Enter an Administrator name and password, and click [OK].
NOTE:
•
For Mac OS X 10.7, click [Install Software].
10
When a message appears telling you installation has completed, click [Close].
This completes the installation.
When using Mac OS X 10.3.9-10.4, proceed to
When using Mac OS X 10.5-10.6, proceed to
Adding a Printer (Mac OS X 10.4)
After the PPD file has been installed, set the PPD file for the print driver, and then add the printer.
The print driver controls the printer functions based on the information in the PPD file.
As an example, this section describes how to add a printer in a Mac OS X 10.4.
1
Start Macintosh.
2
Check that the printer port is set to Enable.
•
When using IP Printing
Set the LPD port to Enable.
NOTE:
•
Printers on an IP network can be detected automatically. To enable the discovery function, start [Bonjour].
•
When using [USB-1(2.0)] / [USB-2(2.0)]
Set the USB port to Enable.
To enable the USB port, see the documentation that came with your printer. Depending on the model being
used, specification of the print mode may be unnecessary.
3
Start [Printer Setup Utility].
NOTE:
•
You can find the Printer Setup Utility in the Utilities folder of the Applications folder.
The [Printer List] window appears.
"Adding a Printer (Mac OS X 10.4)" on page
"Adding a Printer (Mac OS X 10.5-10.7)" on page
Installing of Print Drivers for Macintosh Computers
29.
31.
29
Advertisement
Table of Contents
