Table of Contents
Advertisement
Mirage Reinigungstechnik
23.
HYDRAULIC FLOW SYSTEM
The hydraulic system consists of two circuits:
•
CLEAN WATER / SOLUTION
•
DIRTY WATER / RECOVERY
The circuits described below are with reference to Figures 1,2,3,4,5 and 6 in the section "Machine
description."
23.1
CIRCUIT CLEAN WATER / SOLUTION
1
The clean water has to be inserted along with the detergent into the cap with filter positioned in
front of the scrubber-dryer under the crankcase in red plastic.
2
The solution accumulated into the washing water tank (Ref.1 Figure 1) comes out from the hole
located in the rear of the scrubber-dryer (rif.2 Figure 2), then passes through the filter and the flow
regulating valve in the pipeline.
3
The solution passes through the solenoid valve placed in the front part of the washer-dryer, under
the protective casing of the brush and is delivered directly to the washing brush through the holes.
23.2
CIRCUIT DIRTY WATER / RECOVER
1
The dirty water is recovered from the squeegee bar placed at the rear of the scrubber dryer (ref.6
Figure 1), directly in contact with the ground.
2
The dirty water passes through the suction pipe placed at the rear of the washer dryer (ref.4
Figure 2), connected to the squeegee bar.
3
The dirty water is collected in the recovery tank (ref.3 Figure 1) located in the upper part of the
washer-dryer.
4
The suction of the dirty water is interrupted by the command of the switch placed on the
dashboard (rif.24 Figure 2), or when the water level itself triggers the float located inside the
recovery tank thus avoiding damage to suction motor.
5
The dirty water is discharged by means of the discharge tube (ref.5 Figure 2) which is located at
the rear of the washer dryer.
24.
TROUBLES, CAUSE AND REMEDIES
The table shows a list of the major machine malfunctionings, proposing the cause and the remedy. The last
column shows the type of operator qualified to carry out the operation indicated, where it is reported trained
operator it means that the same operation can also be performed by authorized technician.
PROBLEM
MACHINE DOES NOT
WORK
THE ENGINE STOPS
SUDDENLY
THE WASHING SOLUTION
DOES NOT COME OUT
______________________________________________________________________________________
LIBRETTO USO E MANUTENZIONE
CAUSE
Batteries disconnected
Fuses blown
The motor protection circuit
breaker has intervened due
to overheating
Water filter dirty
REMEDIES
Provvedere al collegamento delle batterie
It has to be replaced as indicated in
paragraph "Fuses replacement"
Wait a few minutes before resuming the
march in order to cool the engine
Clean or replace as described in paragraph
"Water Filter Replacement"
pagina 33
FKC 36 e FKC 46
OPERATOR
Skilled operator
Authorized
technician
Skilled operator
Skilled operator
Advertisement
Table of Contents
