Handlebar Adjustment - Mirage FKC 36 Instruction Manual

Scrubber dryers machines

Hide thumbs

Table Of Contents

Table of Contents

Mirage Reinigungstechnik

16.2.2 Preparation of the machine

After verifying that you have connected the power cable of the battery, turn the main switch key to "ON"

(ref.19 Figure 2) mounted on the dashboard of commands. At this point you can proceed with use.

16.2.3 Detergent choice

For a good cleaning of the floor you have to find the right cleanser, a too aggressive detergent can be

harmful. You need to use low-foaming detergent, or antifoam additive, in order to avoid damage to the

suction motor and not corrosive.

Make sure that the detergent used is appropriate for the type of surface to be treated. Alberti International

Srl is not responsible for damage caused by aggressive detergents or otherwise not suitable for the surface

to be treated.

16.2.4 Tank disassembly

The tanks of the FKC 46 are not removable. To have access to the internal compartment in which are

located the engines and batteries, lift the upper tank bringing the lock to the end limit.

For the FKC 36 the tanks (ref 1 and 2 of Figure 5) are removable to allow access to the operator and the

service technician to the components into the inner compartment.

To extract the recovery water tank:

•

disconnect the float sensor (ref. 10 Figure 5)

•

unscrew the knob (ref. 9 Figure 5) and remove the tank from its seat.

To extract the wash water tank:

•

unhook the quick coupler of water conduit (ref. 14 Figure 6)

•

remove the tank from its seat

•

Proceed in reverse to assembly the machine.

16.3

BRUSH, HANDLEBAR AND SQUEEGEE ADJUSTMENTS

Brush adjustment

16.3.1

To ensure a perfect washing operation, it is essential that the brush is perfectly adjusted.

The adjustment is only possible for the FKC 46 and you need to act on the visible knob in the figure below,

in particular it needs to:

•

turn the knob clockwise to decrease the load on the brush;

•

turn the knob counterclockwise to increase the load on the brush.