REXROTH PSG series Operating Instructions Manual page 102

102 / 170 Bosch Rexroth AG
Safety instructions
| Electric Drives
and Controls
Inappropriate or missing evaluation of error messages
Possibility of reduction of personal/plant safety, function disturban­
ces!
" Messages can be configured freely in the weld timer depending
on your requirements, either as "warning" (no inhibition) or "error"
(with inhibition).
However, messages with error characteristic always have to be
configured as "error" and thus lead to inhibition of the connected
timer!
" Use the available message signals to design the process of your
application as safely as possible.
" With respect to fault analysis, please also refer to the information
in Section „Troubleshooting".
Defective connection of cables
Possibility of reduction of safety of persons/systems, function
disturbances/restrictions!
" All conductor cross-sections should be rated in accordance with
the installed load.
" Make sure that the connecting cables cannot become detached
inadvertently.
" Please note the maximum tightening torque for screws and termi­
nals specified in the technical data.
" Please ensure that the contact areas are bare, i. e. free from
paint, plastic coats or dirt/oxidation.
" Please ensure that the insulation of connecting cables is not
damaged.
PSG xxxx
WARNING
| 1070087062 / 04