Display – Alarms And Warnings - PEUGEOT 208 T16 User Manual

Display – Alarms and Warnings
When an alarm is ON, this page is displayed with a message and the dedicated value
When more than one alarm is active, the most important is displayed. If you want to see the
other alarms, push on the swap alarm button.
Message LED
DO RESET
OIL P LED 1 Blink
OIL T LED 1 Blink
WATER T LED 1 Blink
WATER P LED 1 Blink
P2 KO
LOW BATT LED 2 still
GBOX T LED 2 still
DIFF T LED 2 still
EXAUST T LED 2 still
FUELP KO
FUEL P
P1 KO
HIGH OFF LED 2 still
LOW OFF LED 2 still
PEAL KO LED 2 still
SMOT
LEARN KO
Nturbo LED 1 Blink
Message LED
LEARNING
LOADING
DROPPING
TURBO LED 4 Blink
PARK
GO !!!
LAUNCH
Parameters
Bug init ECU
Low engine oil pressure
High engine oil temperature
High cooling System Temperature
Cooling System Pressure out of range
P2 sensor KO
Low battery voltage
High gearbox oil température
High rear diff oil température
High exhaust temperature T4
Fuel pressure sensor KO
Low fuel pressure
Unplugged P1 sensor
BRK High Current Outlet KO
BRK Low Current Outlet KO
PEAL KO
No engine speed
Learning throttle and pedal position KO
High turbo speed
Parameters
Learning throttle and pedal position
Increasing of the PEAL accumulator pressure
Dropping of the PEAL accumulator pressure
Do not switch off the engine
Handbrake ON
Launch system ready
Launch system ON
ALARMS
Condition
PedThrLearnState >= 8
POil <= 3 bars
TOil >= 140°C
Water_T >= 120°C
PWater <= 1,5 or PWater >= 3 bars
DiagAcqAna0 = 10 or 11
VBatt <= 11,3 V
TGearbox >= 130°C
Tdiff_R >= 120°C
T4 >= 950°C
DiagAcqAna0 = 26 or 27
PfuelHP <= 50 bars
DiagAcqAna0 = 8
BRK_DiagLC1 > 0
BRK_DiagLC2 > 0
Paccu <= 40 bars
BRK_SW = 25
PedThrLearnState = 2
nTurbo >= 200.000 rev.
WARNINGS
Condition
3 <= PedThrLearnState <= 7
Paccu <= 45 bars
Paccu >= 6 bars
T4 >= 600°C
PHandBrake >= 30 bars
P2P >= 1,9 bars
Start 4WD = 1
Secondary condition
RPM = 0
RPM >= 3000 tr/mn and Throttle >= 70°
RPM > 1000
RPM > 1000
RPM > 1000 and Twater >= 90°C
Power On and RPM > 0
RPM > 1000
RPM > 1000
RPM > 1000
RPM > 0 and CarSpeed > 0
RPM > 1000
RPM > 0
ROAD
RPM > 0 and Power On and CarSpeed > 0
RPM = 0
CarSpeed = 0
Secondary condition
RPM = 0
Power On and CarSpeed = 0
Power OFF
ROAD and Gear = 0 and CarSpeed < 10
ROAD and CarSpeed < 10 and PBrakeR <= 5 bars
Launch
CarSpeed = 0 and RPM > 0
Page 25/67
Version 24/04/2015