Operation - Siemens RDF301 Basic Documentation

Layout
Button operation
Siemens
Building Technologies
4.3

Operation

See also Operating Instructions B3171 [2] enclosed with the thermostat.
1
3
RDF301
1 Operating mode selector
2 Button to change fan operation
3 Buttons to adjust setpoints and control parameters
4 Four buttons to control KNX actuators via KNX S-mode
(functions: switching, dimming, blind control, 8-bit scene)
User action
Normal operation
Press any button
(thermostat in normal operation)
Press left button
Press left button (P01 = 2)
Press left button while "Operating
mode switchover" via bus is activated
Press left button >5 seconds
Press right button
Press + or –
Press + and – >3 seconds, release,
then press + again >3 seconds
Press + and – >3 seconds, release,
then press – again >3 seconds
Press operating mode button and "+"
simultaneously for 6 seconds
RDF301, RDF301.50 Basic documentation
Handling
2
1
4
RDF301.50
Effect, description
Actual operating mode and state are
indicated by symbols
Backlit LCD turns on and... (see below for
further action)
After the last operation and a timeout of 20
seconds, the LCD backlight turns off
Change operating mode
Toggle between heating and cooling
Activate "Extend Comfort mode"
(for details, see page 16)
Activate / deactivate button lock
Change fan mode
Adjusts the Comfort room temperature
setpoint .
Thermostat changes to Comfort mode
Go to parameter setting mode "Service
level"
Go to parameter setting mode "Expert
level", diagnostics and test
Enter (KNX) programming mode
2
4
3
65 / 80
CE1P3171en
22 Jun 2010