Fuses And Breakers - Quicksilver 605 Pilothouse Owner's Manual

Quicksilver 605PH — Electrical Systems
damage to electronic components on the boat. Always operate the switch with the engine and
accessories off.

5. Fuses and Breakers

Your boat will either have fuses or breakers protecting the DC electrical system. If you have to replace
a fuse or electrical breaker, replace only with a fuse or breaker of the same rating. The amperage will
be marked on the fuse or breaker, and it is recommended that you carry spare fuses or breakers.
If a fuse or breaker is replaced with one that has a lower amperage, it may not be sufficient to carry
the electrical load of the equipment it is connected to and will cause nuisance failures. If a fuse or
breaker is replaced with one that has a higher amperage, it will not provide protection against an
electrical malfunction and could create a possible fire hazard.
Fuses and breakers
ATO/ATC fuse
Located at the helm, there is a fuse panel accessible via the under dash closeout. To access, simply
remove the vinyl cover under the helm.
Located next to the battery in the starboard aft cockpit floor hatch, there are additional fuse holders.
Their use and size are specified on a label under the hatch that covers the battery.
Auxiliary Fuses
Use only fuses and breakers having the same amperage
rating as the original or as specified. Use of higher
amperage fuses or breakers is a fire hazard.
Thermal breaker ANL fuse
Battery switch
Auxiliary fuses
Battery box
35
Magnetic breaker