Fuses And Breakers - Quicksilver Activ 755 Open Owner's Manual

Quicksilver 755OP — Electrical Systems
The bilge pumps and stereo memory still draw power from
Never work on the electrical system while the system is
the batteries, even if the switches are set to OFF. This is energized. Never leave the craft unattended with the
especially important for the bilge pumps, so that they can
electrical system energized.
operate anytime excess fluid accumulates in the bilge,
which can occur when the boat is docked and unattended.
Non-L6 Battery Switch Operation
OFF Position ON Position
L6 Engine Battery Switch Operation
OFF Position ON Position Combine Batteries

5. Fuses and Breakers

Your boat will either have fuses or breakers protecting the DC electrical system. If you have to replace
a fuse or electrical breaker, replace only with a fuse or breaker of the same rating. The amperage will
be marked on the fuse or breaker, and it is recommended that you carry spare fuses or breakers.
Use only fuses and breakers having the same amperage
rating as the original or as specified. Use of higher
amperage fuses or breakers is a fire hazard.
If a fuse or breaker is replaced with one that has a lower amperage, it may not be sufficient to carry
the electrical load of the equipment it is connected to and will cause nuisance failures. If a fuse or
breaker is replaced with one that has a higher amperage, it will not provide protection against an
electrical malfunction and could create a possible fire hazard.
The 755OP has a breaker panel at the helm, located below the steering wheel. There is also additional
breakers located on the battery switch panel in the cockpit seat storage tub.
42