Gazer CM-272-100 User Manual page 8

ENG
•
Before installing the system, one must decide on the location of following devices: extension microphone, infrared detector (optional), GPS antenna (choose
the location with satellites in the line-of-sight).
•
Lay all the power supply cables under the car upholstery.
•
Connect standard USB and AUX plugs to the multimedia system (depending on the car make and model). We recommend using the USB connector from the
Gazer multimedia system package.
•
Before using the device, remember to insert memory card in the «SD Card» slot.
Warning!
Absence of the memory card may cause functioning issues. Remove the memory card only when the device is off.
•
To fully appreciate all possible functions of a Gazer multimedia system, you should connect it to the Internet. For additional information about internet
connection, please, see the user manual or the following website www.gazer.com – click «Support».
8
Important information
Plug in connectors according to the scheme
While installing Gazer multimedia system, make sure that all the connectors are plugged in accordance with the scheme
(see p. 6-7 «Connection Scheme»).
Connect the power supply correctly
Double check the yellow cable «BAT+», it has to be connected to the positive terminal of the car battery, and the red cable
«ACC» has to be connected to the car's accessory socket (+12B is supplied when you turn the ignition key to ACC position).
Warning! Wrong power supply connection may result in the multimedia system malfunction or failure.
Connect cables correctly
Make sure that the system connection cable 5.1 is plugged in the «F» connector at the back of the board.
Warning! If 5.1 cable is plugged in the «E» connector, your device will malfunction.