Manual Presentation - Lennox MiniAir 10 Installation, Operating And Maintenance Manual

M A +
INI IR
10 – P
S
ECTION RESENTATION

10.1 Manual presentation

This instruction manual supplies the necessary information for the transportation, the installation, operation and
maintenance of the MINIAIR+ apparatus as supplied by the company LENNOX (from this point named as the supplier).
It supplies the user with as much information as is normally useful for a correct and secure installation of the unit.
Lack of observation of the details found within this manual, and an inadequate installation of the MINIAIR+ may cause
the withdrawal of the warranty supplied with the equipment.
Furthermore, the Supplier will not respond to any eventual damage, whether direct or indirect, caused by the incorrect
installation, or for damages caused by the installation being effectuated by inexperienced or unauthorised personnel.
Verify, upon acquisition, that the apparatus is complete and supplied as described.
Any eventual disputes must be presented in writing within 8 days from the reception of the goods.
10.2 Machine identification
The MINIAIR+ Unit is provided with identification plate listing the following:
Address of Constructor
-
"CE" Mark
-
Model
-
Serial Number
-
Maximum Current absorbed in "A"
-
Power supply voltage in "V"
-
Power supply frequency in "Hz"
-
Number of phases indicated with "Ph"
-
Date of fabrication
-
Gross weight in "Kg"
-
11 – T
S
ECTION ECHNICAL
11.1 General characteristics

Completely removable aluzink plate side panels.

Panel thermal and acoustic insulation by means of polyethylene/polyester panels with a medium thickness of 20
mm.

High efficiency aluminium plate static type heat recuperators, with air flows separated by special seals.

UE3 efficiency air filters, which may be easily removed from the sides allowing their periodic cleaning.

Fan bodies mounted on anti-vibrators.

Double inlet centrifugal fans (for MINIAIR+03 single inlet fans) which may be removed from the sides for
periodic maintenance.

Multi-speed directly coupled electric motors..

To aid the electrical connections and ventilator control, a terminal block with a relay board is fitted.

Stainless steel condensation collecting tray, with condensation drainage towards the lower part
11.2 Accessories

Electrical reheating SKE

Water coil for reheating SKW

Regulation damper SKR

Speed selector CVU

Apparatus Control Panel PCU

Pressure operated soiled filter cut-off switch PSTD

Servomotor for damper regulations SSE

Anti-freeze thermostat TEG
IOM / MINIAIR-0507
C
HARACTERISTICS
15