Olympus E-620 Instruction Manual page 107

o
Notes
• Depending on the adjustment made, the lens may not focus toward the
00
or near side.
• When using a teleconverter, the teleconverter and lens are registered as a set.
• Only Four Thirds lenses can be registered.
[DATA LIST]
This displays the lens information registered with
[LENS DATA]
from
[SET AF
DATA].
Select a lens from the list, and then check, delete, or edit the registration
information.
When the same lens is registered
multiple times, the adjustment
value for the lens with ~ is
applied.
Select this to check, delete, or edit
the selected lens.
Select which lens to use
when the same lens is
registered multiple times.
~TIPS
To take pictures while slightly changing the AF adjustment value:
~
After fine-adjusting the adjustment value, press the shutter button and repeatedly take pictures
before pressing the
e
button.
Note the following when taking pictures to check the AF adjustment value.
• It is recommended that the record mode be set to a setting higher than
liN
when taking
pictures.
• Be careful of camera shake, subject movement, and changes in the distance to the subject
when taking pictures.
• It is recommended that you take a picture of a subject with strong contrast within approximately
3 m (9.8 ft.) in the actual shooting environment (lighting and temperature).
• Avoid taking pictures against backlight.
To compare the difference in adjustment values:
~
You can use light box display to compare adjustment values. The adjustment values are also
displayed during light box display.
~"Light
box display" (P. 83)
To register two types of adjustment values (with the focal point of the lens in front of
and behind the subject):
~
You can register multiple adjustment values for the same lens. Select the adjustment value to be
applied during shooting with the [DATA LIST] screen.
To register two of the same type of lens individually:
~ You can individually register multiple numbers of the same type of lens.
To specify and register AF targets, or to register the adjustment values for the wide
and telephoto directions of the zoom:
~ On the [LENS DATA SET] screen, press
8
to make the following settings.
• You can specify individual AF targets and adjust each AF target. Normally, the adjustment
values for all AF targets are registered.
• You can register different adjustment values for the wide and telephoto directions of the zoom.
Normally, the adjustment value for the telephoto direction is registered.
•
o
c:
(fl
-
o
3
E!:
:::s
(Q
'<
o
c: .,
o
OJ
3
ft)
iil
101
EN