Interfaces; Overview; Nb2710 Interfaces - NetModule NB2710 User Manual

3.4. Interfaces

3.4.1. Overview

Label Panel
SIM 1 Front
SIM 2 Front
SIM 3 Front
SIM 4 Front
SIM 5 Front
SIM 6 Front
USB Front
Ethernet 1-4 Rear
Extension Rear
Mob 1 Rear
Mob 2 Rear
GPS Rear
WLAN1 Rear
WLAN2 Rear
Power Rear
RS-232 Rear
Outputs Rear
Inputs Rear
Reset Front
NB2710 User Manual 4.0
Function
SIM 1, it can be assigned dynamically to any modem by configura-
tion.
SIM 2, it can be assigned dynamically to any modem by configura-
tion.
SIM 3, it can be assigned dynamically to any modem by configura-
tion.
SIM 4, it can be assigned dynamically to any modem by configura-
tion.
SIM 5, it can be assigned dynamically to any modem by configura-
tion.
SIM 6, it can be assigned dynamically to any modem by configura-
tion.
USB 2.0 host port, can be used as USB device server or for software
configuration updates.
Ethernet switch ports, can be used for LAN/WAN.
Audio/CAN/IBIS/RS485 extension.
2 SMA female connectors for MIMO LTE antenna
2 SMA female connectors for MIMO LTE antenna
SMA female connector for GPS antenna
2 SMA female connectors for MIMO WLAN antenna
2 SMA female connectors for MIMO WLAN antenna
Power supply 12-48 V (Pins 1 and 2)
DC
Non-isolated serial RS-232 interface (Pins 3 to 5) which can be
used for console administration, serial device server or other serial
based communication applications.
Galvanically isolated digital outputs (Pins 6 to 9)
Galvanically isolated digital inputs (Pins 10 to 13)
The reset button is accessible through a small hole below the USB
connector. Press at least 3 seconds for reboot and at least 10 second
for a factory reset. The start of the factory reset is confirmed by
all LEDs lighting up for a second. The button can be released then
again.
Table 3.2.: NB2710 Interfaces
17