Getting Started; The Reset Button - Oregon Scientific RMR132HG User Manual

Remote unit
Wall-mount Table Stand

THE RESET BUTTON

This button is only used when the unit is operating in an unfavorable
way or malfunctioning. Use a blunt stylus to hold down the button.
All settings will return to their default values.
6
RMR132HG_M_EN_R01

GETTING STARTED

Once batteries are placed in a given remote sensor unit, it will start
transmitting information at 40-second intervals.
Also, for approximately a 3-minute duration, the main unit will
automatically search for signals once batteries are installed. Upon
successful reception, the individual channel temperature reading
will be displayed on the top line and the respective humidity reading
on the bottom line. The main unit will automatically update its
readings at about 40-second intervals.
If no signals are received, blanks " --- " will be displayed and the
kinetic wave icon will not show.
To force a signal search:
´• Press and hold IN/CHANNEL & [MEMORY] for 2-seconds
to enforce a 3-minute search.
This is useful in synchronizing the transmission and reception of
the remote and main units.
Repeat this step whenever you find discrepancies between the
reading shown on the main unit and that on the respective remote
unit.
6
8/13/04, 12:30 PM