Static Ip - Q-See QT5116 User Manual

REMOTE SURVEILLANCE

6.2.2 Static IP:

You will need to setup the network settings on the DVR to match the settings of the router that you attach the DVR to.
To get the router settings you would go to the run option on a computer attached to the same router as the DVR and
type cmd and hit OK to bring up a command prompt (Fig 6.3), then type ipconfig at the prompt (RED arrow on Fig 6.3)
to access the router settings. Write down the gateway and subnet mask numbers (GREEN arrows on (Fig 6.3) so you
can copy them into the network settings on the DVR (GREEN boxes on Fig 6.4). Push the Menu Key on the DVR to
get to the system menu (Fig 6.1) then use the direction keys to select the Network option (Red box in Fig 6.1) to
display the NETWORK screen shown in Fig 6.4.
QT518 & QT5116 User Manual
Fig 6.3: ipconfig
Fig 6.4: Network
50 | P a g e