View Settings; Network Profile - Hama IR50 Operating Instructions Manual

Manual configuration wireless (WLAN) –
DHCP disable
The method described here assumes the DHCP server
is active (manual wireless configuration (WLAN) –
DHCP enable). However, the network information such
as IP address, subnet mask, gateway address, and DNS
(primary and secondary) must still be entered. Find this
information in the web interface of your router or access
point, or ask your network administrator. Once all the
information has been entered correctly, confirm to proceed.
The radio now attempts to establish the connection.

13.2.4 View settings

Here you can find all the most important information
about all network connections currently used or configured
on the radio, such as: MAC address, WLAN region, DHCP
active/ disabled, SSID, IP address, subnet mask, gateway
address, DNS (primary and secondary), etc.
Press and hold
[ ]/[ ]
System settings

Network

View settings
21

13.2.5 Network profile

The radio automatically saves all successfully connected
network profiles.This means that re-establishing these
connections (for example, after the radio was disconnected
from the power supply) does not require you to re-enter
the network access information.
• To remove network profiles individually, proceed
as follows:
Press and hold
• Select a network profile and press
[ENTER/NAVIGATE] to delete it.
• Confirm the prompt querying if you want to
delete the profile with YES.
• A profile that is currently active, or that is in
use, cannot be deleted.
Note - Data security
• Before giving or selling the radio to someone else,
we recommend performing a Factory Reset.
• This will completely and permanently delete all
network information and connections stored on
the device.
[ ]/[ ]
System settings

Network

Network profile