Manual Configuration Of Network Connection - Wireless (Wlan); View Settings; Network Profile - Hama DIR3200SBT Operating Instructions Manual

Note
• Often the Pre-Shared Key is printed on the back of the
router or access point.
• When entering the key, take notice of capitalisation.
Open network / unsecured network
Note
• We recommend against establishing unsecured
connections and advise you to always protect your
network against unauthorised access.
• If you plan to use an open network, you just have
to select the network from the list of available
networks and confirm. The radio then connects
immediately with the access point.
16.2.3 Manual configuration of network
connection – wireless (WLAN)
• To manually configure a network connection, proceed
as follows:
• Press [ ] (7) to go to the system settings.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11) to
navigate to the "Internet settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (11).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11) to
navigate to the "Manual settings" menu item.
Manual configuration wireless (WLAN) – DHCP enable
• Select the option "Wireless".
• Selection the option "DHCP enable".
• In the input screen, enter the whole SSID (network name)
and then confirm with the OK button.
• Now choose the security standard used by the network.
This can be found in the configuration options of your
router or access point.
• Depending on the encryption used, you may need to enter
the network key before the connection is established.
Manual configuration wireless (WLAN) –
DHCP disable
This method corresponds to configuration with an active
DHCP server (manual configuration wireless (WLAN) -
DHCP enabled), however you must also enter the
network information such as the IP address, subnet mask,
gateway address and DNS (primary and secondary).
Find this information in the web interface of your router
or access point, or if this information is already correctly
entered, you can confirm the entry. The radio now attempts
to establish the connection.

16.2.4 View settings

This is where you will find all of the key information about
all network connections that the radio is currently using, or
which have been set up, e.g.: MAC address, WLAN region,
DHCP enable/disable, SSID, IP address, subnet mask,
gateway address, DNS (primary/secondary), etc.
• Press [ ] (7) to go to the system settings.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11)
to navigate to the "Internet settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (11).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11)
to navigate to the "Show settings" menu item.

16.2.5 Network profile

The radio automatically saves all successful network
connections (profiles). This means that re-establishing these
connections (for example, after the radio was disconnected
from the power supply) does not require you to re-enter
the network access information.
To remove network profiles individually, proceed as follows:
• Press [ ] (7) to go to the system settings.
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11)
to navigate to the "Internet settings" menu item.
• Confirm the selection by pressing [POWER/VOLUME/
ENTER/NAVIGATE] (11).
• Use [POWER/VOLUME/ENTER/NAVIGATE] (11) to
navigate to the "Remove network profiles" menu item.
22