Disassembly For Repair - Kenwood TK-3202 Service Manual

TK-3202
Removing the Case Assembly from the Chassis
1. Remove the volume knob (
2. Remove the two screws (
3. Lift and remove the chassis from the case assembly (
(Use a flat-blade screwdriver to easily lift the chassis.)
➌
➌
➍
Removing the TX-RX Unit from the Chassis
1. Remove the packing (
RX unit.
2. Remove the eleven screws (
3. Remove the fixing bracket (
4. Remove the solder of the antenna terminal with a solder-
➑
ing iron ( ).
5. Remove the solder of the positive terminal with a solder-
➒
ing iron ( ).
Note: You can remove the TX-RX unit from the chassis
without removing the solder at the positive terminal.
However, in this case, you can not attach the packing
(G53-1605-03) that is on the positive terminal to the chas-
sis in assembling. So, it is advisable to remove the solder
on the positive terminal first.
6. Remove the FPC from the flat cable connector (
7. Lift and remove the TX-RX unit from the chassis ( ).
➏
➒
4

DISASSEMBLY FOR REPAIR

➊
) and channel knob (
➌
).
➎
) from the SP / MIC jack of the TX-
➏
) fixing the TX-RX unit.
➐
) of the SP/MIC.
➓
➏
➑
➐
➏
➏
➏
➏
➏
➏
➎
Removing the Battery Release Lever from
➋
).
the Case Assembly
1. Press the upper part of the lever toward the inside of the
➍
).
case assembly. One side of the shaft will be removed
➊
( ).
➊ 2. Lift and remove the battery release lever from the case
➋
assembly (
Attaching the Battery Release Lever to the
Case Assembly
1. Insert one side of the shaft into the hole at the lever fitting
section on the case assembly (
Caution: The thin spring (G01-4543-04) should be posi-
tioned above the two tabs of the lever.
2. Tilt the battery release lever slightly forward (
the thick spring (G01-4542-04) is positioned below the
case surface.
3. With the thick spring positioned below the case surface,
attach the other side of the shaft to the case assembly by
pressing the battery release lever (
➍
place ( ).
Caution: Be careful not to tilt the battery release lever too
forward.
If the battery release lever is pushed in this state where
the two tabs come below the case surface, there is a pos-
sibility of damaging the two tabs.
).
Two tabs
A thick spring
➓
➋
).
➋
➊
➊
).
➌
) until it snaps into
A thin spring
Shaft
➊
➌
➋
), so that
➋
➍