Kenwood TK-3202 Service Manual page 6

Assembling the Battery Release Lever
➋
1. Place the lever ( ) onto the stopper (
➌
2. Place the thick spring ( ) onto the lever.
3. Hook the right and left ends of the thin spring (
tabs of the stopper, then place the thin spring onto the
➎
lever ( ).
4. Slide the shaft through the hole of the stopper and lever
➏
( ).
➍
➌
➎
➋
➊
Cautions for Assembly
■ Attaching the positive terminal to the chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly (
the positive terminal.
2. Mount the packing of the positive terminal into the chassis
➌
hole ( ).
3. Mount the holder assembly into the packing of the posi-
➍
tive terminal ( ).
➋
➊
➍
DISASSEMBLY FOR REPAIR
➊
).
➍
) onto the
➏
➋ ➊
) from the packing ( ) of
➌
■ Mounting the chassis to the case assembly
1. Confirm that the waterproof packing attached to the cir-
cumference of the chassis is securely inserted in the
➊
groove of the chassis ( ).
2. Twist the speaker wires twice, then attach the speaker to
the speaker recess of the case assembly (
the speaker is securely inserted.
➊
Confirm that the
waterproof packing is
securely inserted in the
groove of the chassis.
3. Insert the upper part of the chassis into the case assembly
➌
( ).
Caution: Take care that the speaker lead wire is not
caught by the microphone element.
➍
4. Press the chassis ( ) and the case assembly together to
attach them.
Caution: If the packing of the SP/MIC does not come to
the correct position after attaching the chassis to the case
assembly, reposition the packing with your fingers.
➍
➍
TK-3202
➋
). Make sure
➋
➌
5