Kenwood TK-3202 Service Manual page 25

TK-3202
Common Section
Item Condition
1. Setting 1) BATT terminal voltage: 7.5V
2) SSG sandard modulation
Wide 5k
MOD: 1kHz, DEV: 3kHz
Wide 4k
MOD: 1kHz, DEV: 2.4kHz
Narrow
MOD: 1kHz, DEV: 1.5kHz
2. VCO lock 1) CH: High
voltage
• RX
2) CH: Low
• TX 3) CH: High
PTT: ON
4) CH: Low
PTT: ON
Transmitter Section (Note: The market code of the E3 do not perform "Wide 4k" adjustment)
Item Condition
1. Frequency 1) CH: High
adjustment PTT: ON
2. High power 1) Test CH: Low, Low', Center,
adjustment High', High (5 points)
BATT terminal voltage: 7.5V
PTT: ON
3. Low power 1) Test CH: Low, Low', Center,
adjustment High', High (5 points)
BATT terminal voltage: 7.5V
PTT: ON
4. Maximum 1) Test CH: Center, Low, High
deviation (3 points)
adjustment AG: 1kHz/150mV
• Wide 5k Deviation meter filter
LPF: 15kHz
HPF: OFF
PTT: ON
• Wide 4k 2) Test CH: Center
PTT: ON
• Narrow 2) Test CH: Center
PTT: ON
5. VOX 1 1) Test CH: Center
writing AG: 1kHz/45mV
6. VOX 10 1) Test CH: Center
writing AG: 1kHz/4.0mV
24
ADJUSTMENT
Measurement
Test-
Unit Terminal Unit
equipment
Power meter Panel ANT TX-RX TC2
DVM TX-RX CV
TX-RX TC1
Measurement
Test-
Unit Terminal Unit
equipment
F. counter Panel ANT TX-RX VR1
Power meter PC
Ammeter
Power meter Panel ANT
Deviation SP/MIC
meter connector
Oscilloscope
AG
AF VTVM
Adjustment
Parts Method
± 0.1V
3.6V
Check 0.6V or more
± 0.1V
3.2V E
3.0V E3
Check 0.6V or more
Adjustment
Parts Method
± 50Hz
High frequency
± 0.1W
KPG-87D 4.0W
(M2) 2.0A or less
± 0.1W
1.0W
1.0A or less
± 80Hz
4.2kHz
(According to the
larger +, –)
± 80Hz
3.4kHz
(According to the
larger +, –)
± 80Hz
2.2kHz
(According to the
larger +, –)
Specifications/Remarks
Specifications/Remarks