Realignment - Kenwood TK-3202 Service Manual

1. Modes
User mode
Data programming mode
PC mode
PC test mode
Mode
User mode For normal use.
PC mode Used for communication between the
transceiver and PC (IBM compatible).
Data programming Used to read and write frequency data and
mode other features to and from the transceiver.
PC test mode Used to check the transceiver using the PC.
This feature is included in the KPG-87D (M2).
2. How to Enter Each Mode
Mode
User mode Power ON
PC mode Received commands from PC.
3. PC Mode
3-1. Preface
The transceiver are programmed using a personal com-
puter, a programming interface (KPG-22) and programming
software (KPG-87D (M2)).
The programming software can be used with an IBM PC
or compatible. Figure 1 shows the setup of an IBM PC for
programming.
3-2. Connection procedure
1. Connect the transceiver to the personal computer with
the interface cable.
2. When the POWER is switched on, user mode can be en-
tered immediately. When the PC sends a command, the
radio enters PC mode.

REALIGNMENT

PC tuning mode
Function
Operation
RF Power meter
or SSG
When data is transmitting from the transceiver, the red
LED lights.
When data is received by the transceiver, the green LED
lights.
Notes:
• The data stored in the personal computer must match the
model type when it is written into the EEPROM.
• Change the transceiver to PC mode, then attach the inter-
face cable.
3-3. KPG-22 description
(PC programming interface cable: Option)
The KPG-22 is required to interface the transceiver with
the computer. It has a circuit in its D-sub connector (25-pin)
case that converts the RS-232C logic level to the TTL level.
The KPG-22 connects the SP/MIC connector of the trans-
ceiver to the computer's RS-232C serial port.
3-4. Programming software description
KPG-87D (M2) is the programming software for the trans-
ceiver supplied on a CD-ROM. This software runs under Win-
dows 98, ME, Windows 2000 or XP on an IBM-PC or compat-
ible machine.
The data can be input to or read from the transceiver and
edited on the screen. The programmed or edited data can be
printed out. It is also possible to tune the transceiver.
IBM-PC
KPG-87D (M2)
Tuning cable
(E30-3216-05)
Fig. 1
TK-3202
KPG-22
+
Gray
SP
–
Gray/Black
+
1.5D-XV Lead wire
MIC
–
1.5D-XV Shield wire
3