Module Leds; Power Leds; Fan Led; Reset Button - 3Com 3C16895 Installation Manual

14 C 1: S
HAPTER WITCH

Module LEDs

Power LEDs

Fan LED

Reset Button

Fabric 32 Submodules

4-Port 1000BASE-X-GBIC
Submodule
7750 C
OMPONENTS
Table 9 Ethernet Port LEDs (continued)
LED
ACTIVE
The module LEDs show the status of the I/O modules, as described in Table 10.
Table 10 I/O Module LEDs
LED
RUN
ALM
PWR1, PWR2, and PWR3 LEDs show the status of the power modules, as
described in Table 11.
Table 11 Power LEDs
LED
OK
FAIL
Fan LEDs show the status of the fan frame, as described in Table 12.
Table 12 Fan LEDs
LED
OK
FAIL
The reset button resets the entire system.
The Fabric 32 provides a slot for one submodule. The Fabric 32 supports the
following submodules:
4-Port 1000BASE-X-GBIC Submodule (3C16874)
■
4-Port 10/100/1000BASE-T Submodule (3C16873)
■
The 4-port 1000BASE-X-GBIC submodule provides four GE full-duplex Ethernet
GBIC ports.
Figure 4 illustrates the 4-port 1000BASE-X-GBIC submodule.
Description
Green — No data is being transmitted.
Green flashing — Data is being transmitted.
Status description
Green or off — The module failed or has not been inserted.
Green flashing — The module is working normally.
Off — The module is working normally or has not been
inserted.
Green or green flashing — The module failed or is not
working normally.
Description
Green — The corresponding power module is working
normally.
Off — The corresponding power module is not working or
has not been installed.
Green — The corresponding power module is not working.
Off — The corresponding power module works normally or
has not been installed.
Description
Green — The fan is working normally.
Off — The fan is not working or has not been installed.
Green — The fan is not working.
Off — The fan is working normally or has not been installed.