Troubleshooting - Electrolux EVEM677SC User Manual

40 www.electrolux.com
13.3 Replacing the lamp
Put a cloth on the bottom of the interior
of the appliance. It prevents damage to
the lamp glass cover and the cavity.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp.
The lamp and the lamp glass
cover can be hot.
CAUTION!
Always hold the halogen
lamp with a cloth to prevent
grease residue from burning
on the lamp.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
or deactivate the circuit breaker.
The side lamp
1. Remove the left shelf support to get
access to the lamp.

14. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
14.1 What to do if...
Problem
You cannot activate or op‐
erate the oven.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
The oven does not heat
up.
2. Turn the lamp glass cover
3. Clean the glass cover.
4. If necessary, replace the lamp with
5. Install the glass cover.
6. Install the left shelf support.
Possible cause
The oven is not connected
to an electrical supply or it
is connected incorrectly.
The oven is deactivated.
The clock is not set.
The necessary settings are
not set.
The automatic switch-off is
activated.
counterclockwise to remove it.
an applicable 300 °C, G9 heat-
resistant lamp.
Remedy
Check if the oven is cor‐
rectly connected to the
electrical supply (refer to
the connection diagram if
available).
Activate the oven.
Set the clock.
Make sure that the settings
are correct.
Refer to "Automatic switch-
off".