Rivets 4; 5,2 and 6,3 mm dia. Aluminium ® and Steel. BULB-TITE Series Numbers: RV 6601 RV 6602 ® RV 6604 RV 6606 RV 6671 RV 6676 AccuBird 1.2. Equipment/Accessories Nosepiece: 17/32 in working position 17/27, 17/29 and 17/24 in nosepiece-holder Wrench: SW 12 (cover for nosepiece-...
** Also available as a complete set (# 50) part no. 725 9290. 1.5. Safety instructions • When not in use, keep the tool in a dry closed Blind rivet setting tool AccuBird ® room, out of reach of children. •...
• The charger must be exclusively used to charge Release the switch and the assembly will return GESIPA batteries. to the start position. • Check regularly cord, plug and device and have –...
• This battery charger should not be operated • The GESIPA batteries can be charged approx. neither by physically disabled or mentally 1.000 times and reaches its maximum capacity affected people, nor by untrained or unskilled only after several charging cycles.
3. Trouble Shooting 3.1. Blind rivet cannot be set Causes Remedy – Battery empty charge, if necessary replace – Jaws dirty or worn clean and lubricate or replace (see 1.8.) – Jaw assembly loose tighten (see 1.8.) – Jaw pusher spring weak replace –...
Damages caused by material or manufacturing faults will be covered by this warranty and will be re- paired or replaced at no cost. Claims can only be accepted if the complete riveting tool (not stripped) is returned to the distributor or GESIPA. Conformity declaration...
Need help?
Do you have a question about the AccuBird and is the answer not in the manual?
Questions and answers