Axis TNS-2 series User Manual page 9

OSD Menu Setting
B-2. HOME POS
This is ability of HOME POSITION, basically include RECOVER. If you have it
ON, Number and relevant ability would be showed up. Time is for Number,
relevant ability is for operation.
Possible to set up the time by using Left/Right of Joystick, if you press the
Focus Far Key, ■ would be showed up on the left side of Menu, and "[ ]"
can be changed into other ability by using Left/Right as users want. If you
press the Focus Far Key after finish setting of "[ ]", ■ should be taken off and
escaped from "[ ]".
• Possible time of setting: 15~90(Possibly setting as 5unit.)
• Possible list of setting: [AUTO] - RECOVER function performance.
(Performed ability movement last time.)
[PRST1] ~ [PRST8] - PRESET1 ~ PRESET8 movement
[TOUR1] ~ [TOUR8] - TOUR1 ~ TOUR8 movement
[PATT1] ~ [PATT8] - PATTERN1 ~ PATTERN8 movement
[SCAN] - AUTOSCAN movement
B-3. MANUAL SPEED
You can set it up by 100º~250º/sec with maximum speed when user control
PAN/TILT.
B-4. AUTO FLIP
Possible setting up the ON/OFF, on ON, angle of the tilt should be
approached to 90º while PAN/TILT. In case of controlling automatically, Tilt
would be located by -2º after circuit 180º. That means, possible to check the
area of 184º.
B-5. ZOOM SPEED
Possibly set up the Fast/Slow and it decides speed of approaching of zoom
position by adjusting speed of ZOOM MOTOR.
B-6. ALARM
Alarm can set up the 4 input line and 1 COMMON wiring on perception of
the designed input change to SPEED DOME.
• Disable : Clear ALARM movement.
• ENABLE : Performance the designed movement about ALARM occurrence.
PTZ CAMERA
016
OSD Menu Setting
B-7. LANGUAGE
This is for setting the language of OSD MENU and basically include ENGLISH
/ ITALIAN / POLISH. Change into Left / Right of Joystick.
B-8. NEXT PAGE
You can get into the Next Page by using Left / Right of Joystick.
B-9. SAVE AND EXIT
It can be used to save and taking out in the DOME SET, it wouldn't work out
to save the data in case getting out of Menu using EXIT.
B-10. EXIT
It's used to get out of Menu not to save the set value.
SAVE AND EXIT must surely be used in case of save.
C. DOME SET #2 [NEXT PAGE]
SYSTEM LOCK
[PASS WORD]
[OSD DISPLY]
[SYSTEM STATUS]
[INITIALIZATION]
[PREVIOUS PAGE]
C-1. SYSTEM LOCK
Possibly set up the ON / OFF, in case of ON, when getting in the OSD MENU,
set the function using password to prohibit from others except for manager.
C-2. PASS WORD
It is feasible to use that function when SYSTEM LOCK is ON, instruction is
below.
ENTER PASSWORD
BY ENTERING PRESET CODE !
PASSWORD ***
CONFIRM ***
DOME SETUP
OFF
DOME SETUP
017
PTZ CAMERA