Axis TNS-2 series User Manual page 12

OSD Menu Setting
D-6-2. HLC MODE (High Light Compensation)
BLC MODE
LEVEL SET
MASK COLOR
EXIT
• LEVEL SET : Possible to set up into HIGH/LOW.
• MASK COLOR : Higher the number, closer to black and feasible to set up
01~16
D-6-3. SSDR MODE (Samsung Super Dynamic Range)
BLC MODE
LEVEL SET
MASK COLOR
EXIT
• RANGE SET : Possible to set up into WIDE/NARROW
• LEVEL SET : Setup 00~16
D-7. D/N MODE
Setting up the DAY&NIGHT.
- It can be set up 3Mode of DAY/NIGHT/AUTO in total using Left/Right of
Joystick, in case with IR_LED, should be on ON when NIGHT MODE, be
Controlled LED brightness by ZOOM.
- In case of AUTO, it would be changed automatically using amount of lights
and No IR LED, possible to set up the changed speed [SLOW/FAST] using
Focus Far Key.
- In case with IR LED, possible to change it 0~10 stage using Focus Near Key.
PTZ CAMERA
BLC SET
HLC
HIGH
07
BLC SET
SSDR
WIDE
008
022
OSD Menu Setting
D-8. SENSE UP
You can set up the Digital Slow Shutter, not doing anything directly. In case
on ON sense up, Shutter Speed should be adjusted according to amount
of lights. Then Slow Shutter is not working that the section set to Sense up
would be Limited.
- Possible to set it up using Left/Right of Joystick , maximum is x2~x512
* SENSE UP is not applied in case controlling Shutter Speed with manual.
D-9. AGC MODE : Auto Gain Control
Possible to set up 4 mode of OFF/LOW/MIDDLE using Left/Right of Joystick.
D-10. SSNR : Samsung Super Noise Reduction
Possible to set up 4 mode of OFF/LOW/MIDDLE using Left/Right of Joystick.
D-11. COLOR
Set up the Color of display and control every 5 out of 0~100. Lower the
number, closer to black and white, higher the number , color would be
stronger.
The value of Default is 50
D-12. DIS
This is for Digital Image Stabilizer, control the ON/OFF using Joystick.
D-13. IRIS SET
Set up the Iris (AUTO,MANUAL)
- AUTO : IRIS is operating automatically.
- MANUAL : On Manual Mode, F1.6 would be signed and if you press Focus
Far Key, ■ should be showed up and then can be changed using Joystick
Left/Right.
If you press Focus Far Key after completing setting,■should be
disappeared and setting value would be saved.
The Range for change is CLOSE, F1.6~F28
PTZ CAMERA
023