Main Menu; Dome Setup; Camera Set; Ptz Camera - Axis TNS-2 series User Manual

OSD Menu Setting
• Password should be inputted 2 times using number, preset key.
• In case of same thing with PASSWORD input of 2 times, "CONFIRMED"
will be showed up and back to the Menu after 4 second.
• Basic value of PASSWORD : 99
C-3. OSD DISPLAY
Each part can be set up into ON/OFF, on On, remark operating sign in the
designed place.
CAMERA ID
PRESET ID
SECTOR ID
TOUR ID
PATT ID
SCAN ID
COORDINATE
[PREVIOUS PAGE]
C-4. SYSTEM STATUS
This is for checking the information of IR SPEED DOME, instruction is below.
PROTOCOL
BAUD RATE
FIRMWARE VER
UPGRADED DATE
CAMERA MODULE
R/B UPGRADED DATE 01.K.10
[PREVIOUS PAGE]
• PROTOCOL : Communication Protocol information between Controller and
SPEED DOME.
• RAUD RATE : Communication Speed information between Controller and
SPEED DOME.
• FIRMWARE VER : Version information of Firmware used in product.
• UPGRADED DATE : Information on final writing day of the firmware.
• CAMERA MODULE : Module information used in product.
• R/B UPGRADED DATE : Information of final writing day on firmware of the
REAR BOARD.
OSD DISPLAY
ON
ON
ON
ON
ON
ON
ON
SYSTEM STATUS
PELCO-D, P
2400 BPS
1.00a
09.02.11
SCM3270
018
OSD Menu Setting

PTZ CAMERA

C-5. INITIALIZATION
This is for removing the informations of PRESET/TOUR/SECTOR/PRIVACY/
PATTERN saved in Memory, on choice for LOAD OPTIMIZED DEFAULT, all of
value should be initialized to FACTORY DEFAULT.
C-6. PREVIOUS PAGE
THis is for moving on former page.
D. CAMERA SET
• You can set it up on module operating in the CAMERA SET MENU.
• Possible to enter using Left/Right of Joystick after choose CAMERA SETUP
from MAIN MENU OSD.
INITIALIZATION
[TOUR CLEAR]
[PRESET CLEAR]
[SECTOR CLEAR]
[PRIVACY CLEAR]
[PATTERN CLEAR]
[LOAD OPTIMIZED DEFAULT]
[PREVIOUS PAGE]

MAIN MENU

DOME SETUP

CAMERA SET

PRESET
AUTO SCAN
TOUR
PRIVACY
PATTERN
ALARM
SECTOR
EXIT
019
PTZ CAMERA