Axis TNS-2 series User Manual page 6

Installation
PTZ CAMERA
Get wiring through to the back side of
wall pushing to hole inside of bracket.
Unite with product using screw M4×18
from top of bracket.
(Screw Locking Torque : 10.0 kgf.cm)
Make the setting over after double-
check both horizon and position of
product.
010
Quick Operating Keys
The dome supports Pelco-D/P, SAMSUNG and VICON i3DVR(SAE) protocols.
The dome may be used with any controller or DVR etc that supports the Pelco D
and Pelco P protocols.
The default setting of the dome is Pelco D / P (auto detection) with 2400 bps
(baud rate).
[PELCO D/P PROTOCOLS]
The comprehensive feature set of the dome is available from Pelco compatible
controllers via quick operation keys as defined below.
1~64 + preset and 100~255 + preset are used for normal user presets.
Presets 65-99 + are reserved for special functions.
For example, to enter OSD MENU, press the button 95 + PRESET
<Quick Operation Key Table 1>
Number Note
1~64,100~255 +Preset Preset
65 +Preset Preset Status
66 +Preset Auto Scan
67 +Preset Auto Flip
70 + Preset VIB CORR
71~78 + Preset Group Tour
81~88 + Preset Pattern
91 + Preset Zero Position
92 + Preset Freeze
93 + Preset BLC
94 + Preset Day / Night
95 + Preset OSD
96 + Preset Focus Adjust
97 +Preset Alarm
98 +Preset AUX 1
99 +Preset AUX 2
<Quick Operation Keys Table 2: Use these function keys if controller has these keys>
Menu
Tilt Up / Down Sub menu cursor moves up / down
Pan Left / Right Enter to the sub menu or status change or decrement
Focus Near Using for Enter key when user select YES or NO
Focus Far Using for function changing keys when set coordinate
Zoom Tele Status cursor to the right
Zoom Wide Status cursor to the left
Function
Executing Preset 1 ~ 64, 100~255
Display Preset Status
Executing Auto Scan
Selectable On/Off in Auto Flip mode
Selectable On/Off in Picture Stabilization function
Executing Group Tour #1 ~ #8
Executing Pattern #1 ~ #8
Searching Pan / Tilt Zero Position
Select Freeze image when camera is working
Selectable On/Off in BLC function
Selectable Day / Night / Auto Mode
Entering OSD Main Menu
Focus adjust
Selectable Enable/Disable all Alarms
Selectable On/Off in Aux1
Selectable On/Off in Aux2
Function
011
PTZ CAMERA