Quick Operating Keys; Diagnostic - Axis TNS-2 series User Manual

Quick Operating Keys

• 65 + preset : "Preset Status" is displayed, to remove this screen, press Focus Near
button.
• 70 + preset : This feature provides picture stabilization image.
• 92 + preset : This feature freezes the current live image during tour, auto scan
or pattern operation. When you press 92 + preset button, the image freezes but
the camera is still working as per operation such as tour, pattern or auto scan.
This feature is operated by preset number but not included in OSD main menu.
To return to normal images, press 92 + preset button again.
• Due to Zoom camera module, OSD Menu not provides every feature.
In this case, "Not available" is displayed on the monitor.
PTZ CAMERA
012

Diagnostic

Whenever the dome is powered on, a standard diagnostic is operated.
CAMERA ID : 001
BAUD RATE : 2400BPS
WAITING............
A. Pan Origin Test
Zero point of Pan is located during the Panning test.
B. Tilt Origin Test
Zero point of Tilt is located during the Tilt test.
C. TX connection Test
Wait for 60 seconds for TX Connection Test,
During 60 seconds, the camera is must received a signal by any control
equipment
as DVR or controller.
Then Ok is displayed then automatically verifying TX Connection Test.
* If "Not Tested" is displayed in the test,
- The result which is not received any signal from DVR or controller
- Wrong connecting way such as the protocol, baud rate or RS-485
connection.
The use may check the install way carefully.
D. Camera Comm. Test
Camera communication is also checked.
OK should be displayed in these four tests before installation.
If all the above Tests are OK, "NOW EEPROM CHECKING" and "ALL DATA
INITIALIZING" is displayed and the camera is ready to operate.
PTZ CAMERA
PAN ORIGIN TEST OK
TILT ORIGIN TEST OK
TX CONNECTION TEST OK
CAMERA COMM TEST OK
013