Precisionhd Camera 1080P12X - Cisco Precision 40 Manual

Cisco TelePresence PrecisionHD Camera
Contents Introduction

PrecisionHD Camera 1080p12x

The PrecisionHD Camera 1080p12x has DIP switches for video
output format setting.
NOTE: The early shipments of the Quick Set C20 came
with an interim version of the PrecisionHD Camera 1080p4x
(the PrecisionHD Camera 1080p4x*). The interim version has
DIP switches for video output format setting, see the table on
this page.
Video output formats
The DIP switches 1 to 5 set the video output format for the
camera. The DIP switches are located under the camera. The
default setting is Auto, see the table to the right.
Maximum resolution:
• 1080p60 for PrecisionHD 1080p12x zoom
• 1080p30 for PrecisionHD 1080p4x* zoom
• 1080p30 for HD-SDI**
Line voltage frequency
The camera automatically detects the line voltage frequency
when it is 50 or 60 Hz. If there is a different line voltage, you
can set the video output format to a specific value (use the DIP
switches) to override the auto frequency detection.
Set the PrecisionHD 1080p DIP switch (country specific
setting):
• 50 Hz: 00011, gives 1080p50 (720p50 for HD-SDI)
• 60 Hz: 00100, gives 1080p60 (720p60 for HD-SDI)
When using a Cisco codec, it is recomended to use 60 Hz.
D14640.17 Cisco Telepresence PrecisionHD Camera Guide APRIL 2017
Physical interface Connecting the camera
DIP switch table
DIP Switch table for video output formats
1 2 3 4 5
0 0 0 0 0
0 0 0 0 1
0 0 0 1 0
0 0 0 1 1
0 0 1 0 0
0 0 1 0 1
0 0 1 1 0
0 0 1 1 1
0 1 0 0 0
0 1 0 0 1
PrecisionHD 1080p12x, from below
26
Daisy chaining
HDMI HD-SDI**
Auto
1920x1080p25 1920x1080p25
1920x1080p30 1920x1080p30
1920x1080p50** 1280x720p50***
1920x1080p60** 1280x720p60***
1280x720p25 1280x720p25
1280x720p30 1280x720p30
1280x720p50** 1280x720p50***
1280x720p60** 1280x720p60***
Software control
0
Camera guide
Video output format Video output format Appendices
The table shows the different settings avail-
able for the HDMI and the HD-SDI outputs.
Auto: Camera negotiates format over
HDMI. HD-SDI tracks HDMI and defaults to
1080p30 in absence of HDMI sync. This is
the default setting.
Software: For more on the Software control
setting, read about video mode selections
in the Appendix section. Go to:Camera
control with VISCA™ protocol.
* Available for a limited period of time.
** Not supported with Codec C20.
*** Do not use with the PrecisionHD Camera 1080p4x*.
The DIP switches 1 to 5
1
Copyright © 2017 Cisco Systems, Inc. All rights reserved.