Renault LAGUNA Driver's Handbook Manual page 64

TRIP COMPUTER: trip settings
The display of information shown below DEPENDS ON THE VEHICLE EQUIPMENT AND COUNTRY.
Examples of selections
On-board computer with mileage-
before-service message
SERVICE INTERVALS
Resetting: to reset the distance before service, press and hold button 2 or 3 for approximately 10 seconds until the display
shows the mileage permanently.
NB: if a service is performed without changing the engine oil, only the mileage before the next service should be reset. In the
event of an oil change, both the distance before the next service and the next oil change should be reset.
1.58
(3/6)
c) Mileage before service or oil change.
Service in
30 000 Kms / 12 mo.
Service due in
300 Kms / 24 days
Service required
Interpreting the display selected
Mileage before service
With the ignition switched on but the engine not running,
when the message "SERVICE INTERVALS" is displayed,
press button 2 or 3 for about five seconds to display the mile-
age before the next due service.
Distance remaining until the next service (displayed in miles/
kilometres and months), then when the service nears, several
scenarios are possible:
– distance/time remaining less than 900 miles (1,500 km)
or one month: the message "Service due in" is displayed
along with the nearest limit (distance or time);
– range equal to 0 km/miles or service date reached: the
message "Service required" is displayed accompanied by
©
warning light .
The vehicle requires a service as soon as possible.