Electrical Connection; Aligning The Appliance - Bosch KAN56 Operating And Installation Instructions

en
S Using the enclosed clips, attach the
connecting line to the rear panel of
the appliance and to the room wall.
S Place the connecting line in loops or
coils so that the appliance can be
moved away from the wall.
Installing the filter in the water
supply line
S Connect the ends of the connecting
line to the filter (1). Observe the
direction of flow printed on the filter!
S Attach the filter holder in a suitable
position on the left or right of the
appliance (e.g. base unit) (2) and
insert the filter (3).

Electrical connection

Do not use any extension cables or
distributors. This appliance must be
connected to a permanently
installed socket.
The socket to which the appliance is
connected must be easily accessible.
Connect the appliance to
220 240 V/50 Hz alternating current via
a correctly installed earthed socket.
The socket must be fused with a 10 A
fuse or higher.
If the appliance is to be operated in
a non European country, check on
the rating plate whether the indica
ted voltage and current type corres
pond to the values of your mains
supply. The rating plate is situated
in the bottom left hand side of the
appliance. The power cord may be
replaced by an electrician only.
Warning!
!
Never connect the appliance to
electronic energy saver plugs
(e.g. Ecoboy: Sava Plug) or to
power inverters which convert the
direct current to 230 V alternating
current (e.g. solar equipment, power
supplies on ships).
Important!
When installing or changing the power
cord, attach a cord grip.
17
Checking the water
connection for leaks
S Switch on the appliance according
to the enclosed operating
instructions.
S Remove water according to the
operating instructions. This will last
several seconds as there is still air in
the lines and water tank.
S Check all screw on water
connections for leaks on the
appliance and on the water
connection.
S After checking for leaks, pull out the
mains plug again and attach the
motor compartment cover.

Aligning the appliance

To ensure that the appliance functions
correctly, it must be set level with a
spirit level.
If the appliance is not level, water may
flow out of the ice maker, ice cubes
may be irregular or the doors may not
close properly.
S Place the appliance in the designated
location.
S Attach the enclosed base panel with
3 screws.
S To prevent the appliance from rolling
away, screw down the front feet until
they are positioned firmly on the floor.
S Rotate the feet until the appliance
is aligned exactly. Use the doors as
a reference point!
Freezer compartment door is deeper:
Refrigerator compartment door is
deeper: