Connecting The Appliance To The Water Supply - Bosch KAN56 Operating And Installation Instructions

If the depth of the adjacent kitchen
equipment is more than 60 cm,
observe lateral minimum distances in
order to utilise the full door opening
angle.
Door opening Minimum distance
angle
90 °
135 °
If a panel or cupboard is installed above
the appliance, ensure that a gap is left
so that the appliance can be pulled out
of the recess if required.
Unscrewing the doors
If the appliance will not fit through the
house door, the appliance doors can
be unscrewed.
We recommend that installation is
carried out by our customer service.
Unscrewing the freezer
compartment door
S Remove lower cover.
S Loosen the hose connection:
Loosen the hose clips on the hose
connection.
Press the clamping ring in the
direction of the arrow and
simultaneously pull the hose out
of the hose connection.
40 mm
140 mm
S Remove the upper hinge cover (1).
S Disconnect the electrical
plug and socket connections (2).
S While holding the door, unscrew the
hinge screws on top (3).
S Lift the door off the lower hinge pin.
Remove and deposit the door with
care! Do not damage the water
line.
Unscrewing the refrigerator
compartment door
S Unscrew the refrigerator
compartment door in the same way
(the refrigerator compartment door
does not feature any electrical
plug and socket connections or
hose connections).
Warning:
Before installing the doors in reverse
sequence, ensure that the appliance is
level in the installation location.
Connecting the appliance
to the water supply
The water may be connected only by
a competent fitter according to the
local regulations of the appropriate
water supply company.
Connect the appliance to a cold water
line.
- Minimum pressure: 0.14 Mpa
(1.4 bar)
- Maximum pressure up to 0.69 Mpa
(6.9 bar)
The tap for connection of the enclosed
line should be freely accessible.
The enclosed connecting lines are
1.5 m and 7 m long.
Taste and odour of the water may be
improved by installing the enclosed
water filter in the water supply.
Electrical connection
S Connect the line to the solenoid
valve.
S Connect the line to the tap.
en
16