Home Info; Account - Lennox iComfort E30 User Manual

Home Network . . . . . . . . . . . . . . . . . . . . . . . .
forget this network
IP address . . . . . . . . . . . . . . .
subnet mask . . . . . . . . . . . .
router
DNS
R S I S . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 8. Verifying Signal Strength

HOME INFO

Selecting this option will allow the home information to be verified and corrected
if necessary. If the home information is missing, then enter the information now.
This information is required to register the system when creating an account. The
information is also used to determine the local weather if the outdoor temperature
display is set to AccuWeather.
There is also a selection option called remove home. Using this feature will remove
the system information from the consumer portal account. This will only remove the
system that is currently being accessed.

ACCOUNT

The account screen will allow the user to set up an account so they may access
their system remotely from the consumer portal. Reasons to create an account:
• To enable remote access to the system using a mobile device with the iComfort
Thermostat App installed. This will allow remote adjustment for temperature
settings and other features.
• To enable the Smart Away feature discussed later in this instruction.
• To directly communicate to the Dealer any issues the system may be incurring.
This menu allows three options:
Using Existing Account
If an E30 account has already been created, then use the sign in option to access
your account. Enter your email address and password to connect your system to
your on-line account.
Creating a New Account
1. Use this option to create an account. Enter your email address and desired
password. Select create new account.
i
192.168.1.4
255.255.255.0
4 - 0
Remove Home
2. The new account screen will appear. Enter your first name, last name and
phone number (optional).
3. Enter an email address and repeat to verify.
4. Create a password under the set password location. Retype the password to
verify.
5. Check the box that will allow your dealer to receive service alerts and possibly
fix your issue remotely (recommended).
6. Check that you agree to the Lennox EULA. Press on LENNOX EULA to read
the end-user license agreement.
If the setup and connection to the Lennox server is successful, a green check mark
will appear above the server icon under the Wi-Fi menu option.
Figure 9. Connection Status
If you do not wish to create your account using the Creating a New Account
screen, then you will need to select the Generate Pin option and write down the pin
number that appears on the screen. The pin number will be used to associate your
system to your user account. First, create your account using either the iComfort
Thermostat App or consumer website. The first time you login to your account the
screen will indicate no iComfort detected. Press on the thermostat image, enter
your pin number, and press add. If you enter the number incorrectly the screen will
indicate the number entered is invalid. Retry again. When successful, the setup will
continue on to the next applicable screen. If you are adding an additional system
to your account, press on the menu and select add iComfort.
NOTE: The generate pin option is not required if the account is setup from the
thermostat or this is a new additional system, login to the account from the
new thermostat.
There is also a selection option after the account is set up and active which is
called move out. Using this feature just like the remove home feature, will remove
the system/home address information from the consumer portal account or mobile
application. This will only remove the system that is currently active. Your account
is still valid.
8
Generate Pin
Move Out