Maintenance And Care - Rinnai RO-E6206XA-EM Operation And Installation Manual

Disconnect the power supply cord before
carrying out any cleaning or maintenance
activities.
Cleaning the oven interior
We recommend you to clean your oven after each
use. Clean with warm soapy water and a soft damp
cloth. Wipe dry with a lint-free cloth. Avoid using
corrosive or abrasive products that could damage
the enamel coating. It is advisable to keep the oven
clean and remove any food deposits. Built-up food
deposits may overheat,
unpleasant odours.
Never line the bottom of the oven with aluminium
foil. The aluminium foil sheet in direct contact with
the heated enamel coating could melt and damage
the enamel coating inside the oven irreversibly.
Cleaning the oven exterior
Enamel or stainless steel surfaces can be cleaned
with warm soapy water and a soft damp cloth. Wipe
dry with a lint-free cloth. Avoid using corrosive or
abrasive products that could damage the surface.
For stainless steel surfaces, always wipe in the
direction of the grain so as not to scratch the
surface. For tougher stains, use a specific non-
abrasive product (please
manufacturer's instructions).
Door glass
Clean the glass using non-abrasive cleaning agents
and sponges. Wipe dry after cleaning.
Door seal
Clean with warm soapy water and a soft damp cloth.
Wipe dry and fix it in place after cleaning.
Glass cover on the oven light
Clean with warm soapy water and a soft damp cloth.
Wipe dry after cleaning.
Cleaning the accessories
Soak in hot soapy water to remove the grease or
food residue. Clean with brush or sponge.
Catalytic layer
Avoid using abrasive cleaning agents on the oven
cavity walls. We highly recommend you to apply
mild cleaning agents onto a damp cloth, and then
wipe the oven interior.

MAINTENANCE AND CARE

release smoke and
observe the
11
Detaching and attaching the oven door
The oven door can be removed for a more thorough
cleaning.
To detach the oven door,
 Open the oven door fully
 Lift up the small levers located on the two
hinges
 Shut the door but not completely
 Hold the door firmly at both sides and lift
upwards off the hinges guide
To attach the oven door, reverse the sequence.
Replacing the oven lamp
Ensure that the power supply cord is disconnected.
 Remove the glass cover of the lamp
 Remove lamp and replace with a similar heat-
resistant bulb of the same characteristics
 Replace the glass cover
Do not lift the door
off by the handle.
The handle could
break and damage
the glass.
Make sure that you
lift the door off
equally on both
sides.
The glass cover on
the oven lamp must
be replaced if it is
damaged.
For purchase of
spare part, please
check with your local
Rinnai Customer
Care Centre.